FAQs & Troubleshooting

Close

1034D

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 24/12/2015 ID: faqh00000492_000

Preparation before threading

Raise the telescoping thread tree to its highest position.
Make sure that the thread holders are in alignment above the spool pins as illustrated below.

image

(1) Thread holder on thread tree
(2) Spool pin
(3) On Two-needle models
(4) Correct position

 

 

image

 

When threading, always thread in this order: upperlooper, lowerlooper, right needle and then the left needle.

 

Related Models

1034D

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.