TJ-4422TN
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/lptj4422tneas.jpg)
TJ-4422TN
Date: 28/09/2020 ID: faqp00100470_003
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
- Turn off the printer.
- Press and hold the right Selection button, and then turn on the Power Switch.
-
Release the button when Factory Default appears on the screen.
You can also release the button when the LED is flashing in green (5 times).
The LED color will change in the following order:Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
Parameter Default setting Speed 152.4 mm/sec (6 ips) (203 DPI)
101.4 mm/sec (4 ips) (300 DPI)
76.2 mm/sec (3 ips) (600 DPI)Density 8 Label Width 101.5 mm (4") Label Height 101.5 mm (4") Sensor Type Gap sensor Gap Setting 3 mm (0.12") Print Direction 0 Reference Point 0,0 (upper left corner) Offset 0 Tear Mode On Peeler Mode Off Cutter Mode Off Rewinder Mode Off Code Page 850 Country Code 001 Clear Flash Memory No
TJ-4420TN, TJ-4422TN
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.