CV3550
FAQs & Troubleshooting |
CV3550
Date: 01/08/2017 ID: faqh00000586_003
How to attach and remove the presser foot
Always be sure to turn off the power before carrying out this operation.
- Turn off the main power and light switch or disconnect the power supply plug.
- Raise the presser foot lever (1).
- Turn the handwheel (2) so that the line on the handwheel is aligned with the line on the machine. (See Turning direction of handwheel )
- Push the button on the presser foot holder (3) to release the standard presser foot.
- Raise the presser foot farther by pushing the presser foot lever upward. Then, remove the presser foot and store it in a safe location.
- Again, raise the presser foot farther by pushing the presser foot lever upward. Place the presser foot just under the presser foot holder (A) so that the groove in the bottom of the presser foot holder (B) is aligned with the bar on the top of the foot (C), and then lower the presser foot lever to attach the foot (4).
CV3440, CV3550
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.