ADS-1100W
![]() |
FAQs & Troubleshooting |

ADS-1100W
Date: 09/09/2015 ID: faq00003156_000
Plastic Card Jam
The Plastic Card Jam message appears if the machine meets the following conditions.
-
The machine was turned on while a plastic card was inserted into the machine.
-
The Card Slot Guide is not adjusted to fit the width of the plastic card.
-
Plastic Card Mode was not set.
- The card is unacceptable for the machine.
When the Plastic Card Jam message appears, the following LED indication is shown on the control panel.
Follow the steps below to solve the card jam.
-
Open the Top Cover (1) and the Front Cover (2).
-
Remove the jammed card.
-
Close the Front Cover and the Top Cover.
-
Press
.
To avoid future card jams, follow the steps below:
-
Make sure that any plastic card is not left in the Card Slot.
-
Adjust the Card Slot Guide to fit the width of the plastic card before inserting the card into the machine.
-
Set Plastic Card Mode.
> Click here to see how to change Scan Settings.
- Load the acceptable card for the machine.
ADS-1100W
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.