FAX-8360P
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/fax8360p_as.jpg)
FAX-8360P
Date: 12/02/2009 ID: faq00002565_000
How do I adjust the settings of the ring volume, beeper volume and speaker volume on my Brother machine?
Please follow steps below:
Adjusting Ring Volume:
You can adjust your Brother machine's ring volume by following these steps:
Adjusting Beeper Volume:- Press Menu or Menu/Set.
- Select General Setup => Volume => Ring.
- Select the volume level. Press OK, Set or Menu/Set.
- Press Stop or Stop/Exit.
You can adjust your Brother machine's beeper volume. When the beeper is on, the Brother machine beeps every time you press a key or make an error and at the end of the sending and receiving faxes.
Adjusting Speaker Volume:- Press Menu or Menu/Set.
- Select General Setup => Volume => Beeper.
- Select the volume level. Press OK, Set or Menu/Set.
- Press Stop or Stop/Exit.
You can adjust your Brother machine's speaker volume by following these steps:
- Press Menu or Menu/Set.
- Select General Setup => Volume => Speaker.
- Select the volume level. Press OK, Set or Menu/Set.
- Press Stop or Stop/Exit.
If Message Center (TAD) feature is available for your Brother machine, you can adjust the speaker volume while you are listening to incoming and outgoing messages on the Brother machine's built-in Message Center (TAD) by pressing or
.
If you turn Incoming Message Monitoring OFF, then you will not be able to hear caller's leaving messages over your Brother machine's speaker. You can still use or
to control the volume during other Message Center (TAD) operations.
FAX-1360, FAX-2480C, FAX-2820, FAX-2840, FAX-8360P, MFC-235C, MFC-240C, MFC-3360C, MFC-440CN, MFC-5460CN, MFC-5860CN, MFC-665CW, MFC-685CW, MFC-7420, MFC-7820N, MFC-9660
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.