HL-5070N
FAQs & Troubleshooting |
HL-5070N
Date: 27/01/2014 ID: faq00000701_004
How do I clean black spots at 108mm (4.25in.) intervals on printed documents?
Firstly make 10 to 15 copies of a blank, white sheet of paper.
If you still see the spots on printed documents after making multiple copies, clean the drum unit as follows:
-
Remove the drum unit and toner cartridge assembly.
-
Position the print sample in front of the drum unit so you will know the exact position on the drum that is causing the poor print.
-
Turn the drum unit gear by hand while looking at the surface of the OPC drum.
-
When you have located the mark on the drum that matches the print sample, wipe the surface of the OPC drum with a cotton swab until the dust or paper powder on the surface comes off.
- Do not use a scrubbing or wiping motion because this might damage the drum.
- Do not try to clean the surface of the OPC drum with a sharp object, such as a ball-point pen, because this might cause permanent damage to the drum unit.
HL-5040, HL-5050, HL-5070N
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.