HL-2070N
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hl2070n_all.jpg)
HL-2070N
Date: 06/09/2006 ID: faq00000402_000
The printer cannot print full pages of a document. An error message PRINT OVERRUN is printed out.
Please do the following:
-
Press the Go button to print the data left in the printer. Cancel the print job if you want to delete the data remaining in the printer.
To cancel printing: while printing press the Go button for about 4 seconds until all the LEDs light up. The Ready and Paper LEDs will flash as the job is being canceled.
-
If this does not clear the error, reduce the complexity of your document or reduce the print resolution.
-
Set page protection AUTO by using the supplied Windows® driver.
Select 'Device Options (5)' in the 'Advanced' tab of the printer driver. Then select 'Page Protection' and set it to 'AUTO'.
![](/g/b/img/faqend/faq00000402_000/in/en/92486/pp.gif)
- Change the following settings in the supplied Windows® driver, and then try again. The best combination of the settings below will vary depending on your document:
+Graphics mode
+TrueType mode (HL-2070N/2075N only)
+Use printer TrueType® fonts (HL-2070N/2075N only)
To change these settings, click 'Advanced' tab of the printer driver. Select 'Manual' in the 'Print Setting' section. Click 'Setting...'.
![](/g/b/img/faqend/faq00000402_000/in/en/92485/4.gif)
HL-2040, HL-2070N
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.