DCP-T820DW
 |
FAQs & Troubleshooting |
DCP-T820DW
Date: 28/10/2020 ID: faq00000105_525
Reset the Network Settings to Factory Default
You can use your machine's control panel to reset the print server to its default factory settings. This resets all information, such as the password and IP address.
This feature restores all wired (supported models only) and wireless network settings to the factory settings.
- You can also reset the print server to its factory settings using Web Based Management.
DCP-T520W/DCP-T525W/DCP-T720DW/DCP-T725DW/DCP-T820DW/DCP-T825DW
- Press Menu.
- Press
or 
to select the following: - Select [Initial Setup]. Press OK.
- Select [Reset]. Press OK.
- Select [Network Reset]. Press OK.
- Press for [Reset] to confirm.
- Press for [Yes] to reboot the machine. The machine restarts.
MFC-T920DW/MFC-T925DW
- Press Settings.
- Press or to make your selections:
- Select [Network]. Press OK.
- Select [Network Reset]. Press OK.
- Press
for two seconds to confirm. The machine restarts.
DCP-T520W, DCP-T525W, DCP-T820DW, MFC-T920DW
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.