Innov-is A16
 |
FAQs & Troubleshooting |
Innov-is A16
Date: 31/07/2020 ID: faqh00101524_000
How do I sew hook-and-loop fasteners(hook-and-loop tapes)?
- Use only the adhesive-free hook-and-loop fastener tape which is designed for sewing. When the glue adheres to the needle or the bobbin case, it may cause malfunction.
- If the hook-and-loop fastener tape is sewn with the thin needle (65/9-75/11), the needle may bend or break.
- Before sewing, baste together the fabric and the hook-and-loop fastener tape.
Make sure that the needle passes through the hook-and-loop fastener tape by turning the handwheel and lower the needle into the hook-and-loop fastener tape before sewing. And then, sew the edge of the hook-and-loop fastener tape at a slow speed.
If the needle does not pass through the hook-and-loop fastener tape, replace the needle with the needle size for thicker fabrics. For details, refer to "Combination of fabric, thread and needle".
 |
(1) Edge of the hook-and-loop fastener tape |
FS60X, Innov-is A16, Innov-is NV180D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?
Please note this form is used for feedback only.