SDX2250D
GYIK és hibaelhárítás |
SDX2250D
Dátum: 03/10/2018 Azonosító: faqh00000691_002
The mat is fed in at an angle.
Possible Causes (or Results)
Case1 : | The mat was inserted into the feed slot at an angle. |
Case2 : | The corners of the mat are deformed (bent). |
Case3 : | The rear tray is not pulled out. |
Case4 : | The feed roller is not positioned correctly. |
Case5 : | The shaft is released. |
Solutions
----- Case1 -----
Press the (Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
Ha további segítségre van szüksége, kérjük, vegye fel a kapcsolatot a Brother ügyfélszolgálatával:
Tartalommal kapcsolatos visszajelzés
Kérjük, segítse munkánkat azzal, hogy visszajelzést küld.
1. lépés: Mennyire volt segítségére az ezen weboldalon kapott információ?
2. lépés: Szeretne még bármilyen megjegyzést hozzáfűzni?
Kérjük, vegye fegyelembe, hogy ezen az űrlapon csak visszajelzéseket várunk.