CM350
 |
FAQs & Troubleshooting |
CM350
Date: 21.03.2018 ID: faqh00100944_000
When a file that contains a pattern with holes is opened, the holes are filled.
When pattern data (CWPRJ file) is exported as an FCM file, then re-imported into CanvasWorkspace, holes in the pattern may be filled.
Data that has been exported as an FCM file cannot be edited again, even if it is re-imported into CanvasWorkspace.
In order to edit the pattern, we recommend that pattern data be saved as a CWPRJ file.
CM350, CM550DX/ CM550, CM900
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.