Install the bobbin wound with thread.
You can begin sewing immediately without pulling up the bobbin thread by simply inserting the bobbin in the bobbin case and guiding the thread through the slit in the needle plate cover.

1. Press  (Needle position button) once or twice to raise the needle.

    

2. Press .
    

   When the message “OK to automatically lower the presser foot? ” appears on the LCD screen, press "OK" to continue.

   The screen changes, and all keys and operation buttons are locked (except  ).

    

3. Raise the presser foot lever.

    

4. Slide the bobbin cover latch to the right.

   (1) Bobbin cover (2) Latch

5. Remove the bobbin cover.

    

6. Hold the bobbin with your right hand with the thread unwinding to the left, and hold the end of the thread with your left hand. Then, with your right hand, place the bobbin in the bobbin case.
   
   

    

7. Lightly hold down the bobbin with your right hand (A), and then guide the end of the thread around the tab of the needle plate cover with your left hand (B).

   (1) Tab

   Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect.

    

8. While lightly holding down the bobbin with your right hand (A), guide the thread through the slit in the needle plate cover (B) and lightly pull it with your left hand (C).
   
   

    

9. While lightly holding down the bobbin with your right hand (A), continue guiding the thread through the slit with your left hand (B) Then, cut the thread with the cutter (C).
   
   

    

   If the thread is not correctly inserted through the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension.

   (1) Tension-adjusting spring

    

10. Reattach the bobbin cover.
    Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side.
    

     

11. Press  to unlock all keys and buttons.