Innov-is 900
 |
FAQs & Troubleshooting |
Innov-is 900
Date: 07.04.2009 ID: faqh00000091_001
How do I remove the presser foot holder?
- Raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up.
With models equipped with
(needle position button), raise the needle by pressing 
(needle position button) once or twice.
or
Mark
Needle position button
- Turn off the sewing machine.
Before replacing the presser foot, be sure to turn off the sewing machine. Otherwise, injuries may occur if a button is accidentally pressed and the machine starts sewing.
- Raise the presser foot lever. The presser foot is raised.
Presser foot lever
- Press the black button at the back of the presser foot holder.
The presser foot holder releases the presser foot.
Black button
Presser foot holder
- Use the screwdriver to loosen the presser foot holder screw.
The presser foot is removed from the presser bar.
Screwdriver
Presser foot holder
Presser foot holder screw
Presser bar
BM-3500/2600, Innov-is 1000, Innov-is 1250, Innov-is 1250D, Innov-is 900, Innov-is 950, Innov-is 980D, Innov-is 980K, Innov-is 985D, NX-200/200QE, NX-250, NX-400Q/400, NX-450, XL-2120/2220/2230/2240, XL-5050/5060/5070
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.