HL-7050
FAQs & Troubleshooting |
HL-7050
Date: 16.10.2006 ID: faq00000292_014
What kind of memory can I use?
The HL-7050 and HL-7050N printer have 32 MB of standard memory (this may vary by country) and two slots for optional memory expansion (both slots will not be available if the printer is supplied with more than 32Mbytes of memory).
You can expand the memory up to 288 MB by installing dual in-line memory modules (DIMMs).
The following DIMM size can be installed:
<US>
Size |
Manufacture |
No. |
16 MB | TECHWORKS | 12456-0001 |
32 MB | TECHWORKS | 12457-0001 |
64 MB | TECHWORKS | 12458-0001 |
128 MB | TECHWORKS | 12459-0001 |
For more information, visit Techworks web site at http://www.techworks.com/
<Europe>
Size |
Manufacture |
No. |
16 MB | Buffalo Technology | 12323-0001 |
32 MB | Buffalo Technology | 12324-0001 |
64 MB | Buffalo Technology | 12325-0001 |
128 MB | Buffalo Technology | 12326-0001 |
In general, the DIMM that can be used with the HL-7050 and HL-7050N must have the following specifications:
Type: | 100 pin and 32 bit output |
CAS Latency: | 2 or 3 |
Clock frequency: | 66 MHz or more |
Capacity: | 16, 32, 64 MB or 128 MB |
Height: | 46 mm (1.8 inches) or less |
Parity: | None |
DRAM Type: |
SDRAM 4 Bank |
Related FAQs
HL-7050, HL-7050N
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.