FAQs & Troubleshooting

Close

Innov-is NV870SE

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is NV870SE

Not your product?

Date: 24/12/2014 ID: faqh00000629_001

How do I set the bobbin ?

 

Install the bobbin wound with thread.
You can begin sewing immediately without pulling up the bobbin thread by simply inserting the bobbin in the bobbin case and guiding the thread through the slit in the needle plate cover.

  • Before inserting or changing the bobbin, be sure to press image on the operation panel to lock all keys and buttons, otherwise injuries may occur if the “Start/Stop” button or any  other button is pressed and the machine starts.
  • Use a bobbin that has been correctly wound with thread, otherwise the needle may break or the thread tension will be incorrect.
    image
  1. Press image (Needle position button) once or twice to raise the needle.

     

  2. Press image.

    When the message “OK to automatically lower the presser foot? ” appears on the LCD screen, press "OK" to continue.

    The screen changes, and all keys and operation buttons are locked (except image ).

     

  3. Raise the presser foot lever.

     

  4. Slide the bobbin cover latch to the right.
    image (1) Bobbin cover

    (2) Latch

  5. Remove the bobbin cover.

     

  6. Hold the bobbin with your right hand with the thread unwinding to the left, and hold the end of the thread with your left hand. Then, with your right hand, place the bobbin in the bobbin case.

    image

     

  7. Lightly hold down the bobbin with your right hand (A), and then guide the end of the thread around the tab of the needle plate cover with your left hand (B).
    image (1) Tab

    Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect.

     

  8. While lightly holding down the bobbin with your right hand (A), guide the thread through the slit in the needle plate cover (B) and lightly pull it with your left hand (C).

    image

     

  9. While lightly holding down the bobbin with your right hand (A), continue guiding the thread through the slit with your left hand (B) Then, cut the thread with the cutter (C).

    image 

     

    If the thread is not correctly inserted through the tension-adjusting spring of the bobbin case, it may cause incorrect thread tension.

    image (1) Tension-adjusting spring

     

  10. Reattach the bobbin cover.
    Insert the tab in the lower-left corner of the bobbin cover, and then lightly press down on the right side.
    image

     

  11. Press image to unlock all keys and buttons.
 

 

Related FAQs

Related Models

Innov-is NV2600, Innov-is NV2650D, Innov-is NV2700, Innov-is NV800E, Innov-is NV870SE, Innov-is NV880E

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.