TJ-4005DN
 |
FAQs & Troubleshooting |
TJ-4005DN
Date: 10/02/2022 ID: faqp00100470_002
How to reset the printer settings by directly operating the printer
Printer initialisation clears the printer's DRAM and restores its factory settings.
- Turn off the printer.
- Press and hold the Pause and Feed button, and then turn on the printer.
-
Release the button when the Power LED is blinking in green (5 times).
The LED colour will change as follows:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
After the initialisation, the following factory settings will be restored:
| Parameter | Default setting |
|---|---|
| Speed | 127 mm/sec (5 ips) (203 DPI) 76 mm/sec (3 ips) (300 DPI) |
| Density | 8 |
| Label Width | 101.5 mm (4") |
| Label Height | 101.5 mm (4") |
| Sensor Type | Gap sensor: TJ-4020TN, TJ-4021TN, TJ-4120TN, TJ-4121TN Black sensor: TJ-4021TNR, TJ-4121TNR |
| Gap Setting | 3 mm (0.12") |
| Print Direction | 0 |
| Reference Point | 0,0 (upper left corner) |
| Offset | 0 |
| Tear Mode | On |
| Peeler Mode | Off |
| Cutter Mode | Off |
| Rewinder Mode | Off |
| Code Page | 850 |
| Country Code | 001 |
| Clear Flash Memory | No |
TJ-4005DN, TJ-4020TN, TJ-4120TN
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.