FAQs & Troubleshooting

Close

TD-4750TNWBR

FAQs & Troubleshooting

FAQs & Troubleshooting

TD-4750TNWBR

Not your product?

Date: 01/12/2021 ID: faqp00100470_001

How to reset the printer settings by directly operating the printer

Printer initialization clears the printer's DRAM and restores its factory settings.

 

  1. Turn off the printer.

  2. Press and hold the Feed/Pause button, and then turn on the printer.

  3. Release the button after the LED flashes in amber five times and lights in green/red (blinks 5 times alternately).

    The LED color will change as follows:

    Amber (lit) > Red/Amber (blinks 5 times alternately) > Amber (5 times) > Green/Red (blinks 5 times alternately) (Release the button here) > Green (5 times) > Red (5 times) > Green (lit)

    After the initialization, the following factory settings will be restored:
    Parameter Default setting
    Speed 76 mm/sec (3 ips)
    Density 8
    Label Width 101.5 mm (4")
    Label Height 101.5 mm (4")
    Sensor Type Gap sensor
    Gap Setting 3 mm (0.12")
    Print Direction 0
    Reference Point 0,0 (upper left corner)
    Offset 0
    Tear Mode On
    Label Peeler off Mode Off
    Cutter Mode Off
    Code Page 850
    Country Code 001
    Clear Flash Memory No

 

< Printer initialization from the LCD >

You can also activate printer initialization from the LCD.

  1. In the LCD, select the Menu icon Menu icon.

  2. In the Main menu, select Advanced.

  3. Select Initialization.

Related Models

TD-4650TNWB, TD-4650TNWBR, TD-4750TNWB, TD-4750TNWBR

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.