RJ-3230B
FAQs & Troubleshooting |
RJ-3230B
Date: 09/09/2021 ID: faqp00100375_001
How to use the Roll Holder Stop
The Roll Holder Stop prevents the Roll Guides from closing. It is ideal to reduce the distance needed to extend the Roll Guides to load the roll.
-
Remove the backing paper from the two locations on the Roll Holder Stop, as shown in the illustration.
-
Extend the Roll Guides outward and attach the Roll Holder Stop to the innermost part of the groove.
- The Roll Holder Stop is compatible with the 76 mm (3 in.) roll width.
- Attach the Roll Holder Stop with the Roll Guides extended outward.
- The Roll Holder Stop can be attached to either side of the groove.
- Attach the Roll Holder Stop to prevent surplus air from accumulating between the adhesive layer and the printer.
- Clean the pasted part of the printer before attaching.
RJ-3230B, RJ-3250WB
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.