QL-1100/1100c
 |
FAQs & Troubleshooting |
QL-1100/1100c
Date: 04/01/2018 ID: faqp00100341_000
When I load a die-cut DK roll in my printer and turn it on, it does not feed any labels.
When loading a die-cut DK roll (such as DK-11208) through the Label Output Slot, make sure that the end of the first label is just visible.
If too much roll or too little roll is fed, the printer cannot read the sensor mark on it, and will not automatically feed the labels.
QL-1100/1100c, QL-1110NWB/1110NWBc
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.