PT-H300
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/h300euk.jpg)
PT-H300
Date: 17/08/2015 ID: faqp00001475_005
How do I set tape margins and what features are there?
-
Press the Label key to display the Label menu.
-
Select "Margin" using the Up or Down arrow key, and then set the value by using the Left or Right arrow key.
-
Press the OK or Enter key to apply the settings.
* New settings are NOT applied if you do not press the OK or Enter key.
Full |
![]() |
- Each label is printed, leaving a margin of 25 mm / 0.98" on each end.
Half |
![]() |
- A margin of 25 mm / 0.98" is printed first, and then each label is printed, leaving a margin of 12 mm / 0.47" before and after the text.
- Dots (:) are printed in front of the text. Cut along the printed dots (:) with scissors.
Narrow |
![]() |
- A margin of 25 mm / 0.98" is printed first, and then each label is printed, leaving a margin of 4 mm / 0.16" before and after the text.
- Dots (:) are printed in front of the text. Cut along the printed dots (:) with scissors.
Chain |
![]() |
- Use this setting when printing several labels with minimum margins.
-
Feed the tape before using the cutter.
Otherwise a part of the text may be cut off. Do not try to pull the tape since this may damage the tape cassette. -
After pressing Print, "OK to Feed?" appears.
Press the Escape key to enter more texts or press the OK or Enter key to feed. - The final label is printed with an 9.5 mm / 0.37" margin to the right of the characters. Use scissors to cut off any part of this margin that is not required.
PT-H300
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.