RJ-2050
 |
FAQs & Troubleshooting |
RJ-2050
Date: 15/09/2016 ID: faqp00001073_007
How do I install/change the label roll?
-
Push the cover open lever to open the RD Roll compartment cover.
1 Cover open lever
-
Inserting or removing the paper or label roll.
-
Insert an RD Roll into the RD Roll compartment with the roll feeding from the bottom as shown.
1 Print surface (faces outwards on the roll)The thermal sensitive side must be on the outside of the roll and installed as shown to print properly.
-
Remove the roll.
-
Insert an RD Roll into the RD Roll compartment with the roll feeding from the bottom as shown.
-
Close the RD Roll compartment by pressing down on the centre of the cover until it latches.
RJ-2030, RJ-2050
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.