QL-820NWB/820NWBc
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/lpql820nwbeuk.jpg)
QL-820NWB/820NWBc
Date: 30/10/2017 ID: faqp00000422_001
Labels are jammed in the machine or are not ejected correctly after printing.
How to remove a label jam:
- Make sure that printer is turned off and disconnect the AC adapter.
- Open the DK Roll compartment cover.
-
Remove any jammed labels.
Do not touch the cutter. Personal injury could result.
How to prevent label jams:
-
If a label causes the machine to jam due to adhesive residue attached to the label outlet, clean the label outlet with a cloth.
Use a slightly damp cloth if it is difficult to remove adhesive. -
Check if there is dirt or lint on the roller preventing it from rolling freely.
Use a cleaning sheet to clean the roller.
For details, see "What are the cleaning sheets for? When do I use them?" - Check that the label output slot is not blocked.
-
Check that the DK Roll is installed correctly. If not, remove the DK roll and reinstall it.
For details, see "How do I install/change the label roll?". - Check that the DK Roll compartment cover is closed correctly.
-
Check that the label is not damp.
Do not expose the DK Roll to high humidity. -
Do not use a label that has already been peeled off by sticking it back to the release paper.
It may peel off and get stuck in the printer.
QL-500, QL-500A, QL-550, QL-560, QL-570, QL-580N, QL-600, QL-700, QL-710W, QL-720NW, QL-800, QL-810W/810Wc, QL-820NWB/820NWBc
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.