FAQs & Troubleshooting

Close

SDX900

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 01/09/2021 ID: faqh00101551_000

How to Use the Roll Feeder 2 Function [Video]

 

Video instructions for using the roll feeder 2 function.

 

 

 

Preparation before using the Roll Feeder 2

  • The software on the cutting machine must be updated to Ver. 1.60 or later to recognize the leader sheet. Otherwise, you may damage the leader sheet.
    If the version is older than 1.60, click here to go to the software download page.
     
  • You must install CanvasWorkspace on your computer.
    If CanvasWorkspace is not installed on your computer, click here to download the application.

    After installing the CanvasWorkspace, activate the Premium Function to use Roll feeder function first.
    For details, refer to How to Activate an Accessory Kit* (Rhinestone, Emboss Kit, etc.) for the Cutting Machine .
    The Premium Function to use Roll Feeder function is common to Roll Feeder and Roll Feeder 2. If you have already activated it, you do not need to activate it again.

 

 

Video instructions: How to Use the Roll Feeder 2

Click on the image to play the video instructions.

* Videos are streamed from YouTube.

 

----- Creating Data on CanvasWorkspace -----

 

----- Installing the Roll Feeder 2 -----

 

----- Trimming the End of the material & Attaching the Leader Sheet -----

 

----- Loading Material into the Roll Feeder 2 -----

 

----- Retrieving Roll Feeder Data on the Machine and Cutting-----

 

 

  • The functions, components or screens shown in this video may differ from the ones that you are using.
  • Video contents may change without prior notice.

Related Models

SDX1200, SDX135, SDX2200D, SDX2240D, SDX2250D, SDX900, SDXTL

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.