FS40s
 |
FAQs & Troubleshooting |
FS40s
Date: 22/02/2024 ID: faqh00101093_005
Fabric puckers
-
There is a mistake in the upper or bobbin threading.
Check the steps for threading the machine and rethread it correctly.
Refer to How do I install the bobbin wound with thread ? , How do I thread my machine ?
-
Spool cap is set incorrectly.
Check the method for attaching the spool cap, then reattach the spool cap.
Refer to How do I thread my machine ?
-
Using improper needle or thread for the selected fabric.
Check the Fabric/Thread/Needle Combinations chart.
Refer to Combination of fabric, thread and needle.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Stitches are too long when sewing thin fabrics.
Shorten the stitch length.
Refer to How do I adjust a stitch width or length ?
-
Thread tension is set incorrectly.
Adjust the thread tension.
Refer to How to adjust the thread tension.
-
Wrong presser foot.
Use the correct presser foot.
Related FAQs
CS10s, FS40s, FS40WTs, FS60x, FS70WTx, SH40
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.