XR-6600
FAQs & Troubleshooting |
XR-6600
Date: 07/05/2015 ID: faqh00100036_010
Tangled thread on wrong side of fabric
Symptom / Cause
-
The thread becomes tangled on the lower side of the fabric.
- After starting sewing, a rattling noise is made and sewing cannot continue.
-
Looking under the fabric, there is tangled thread in the bobbin case.
If the upper thread is incorrectly threaded, the upper thread passed through the fabric cannot be firmly pulled up and the upper thread becomes tangled in the bobbin case, causing a rattling noise.
Remedy / Check details
Remove the tangled thread, and correct the upper threading according to the following procedure.
-
Turn off the sewing machine.
-
Remove the tangled thread. If it cannot be removed, cut the thread with scissors.
-
If the threads remain in the bobbin case, remove the needle plate cover, and then remove the threads.
For details, refer to How do I clean the machine? (Cleaning the race).
If the bobbin was removed from the bobbin case, install the bobbin in the bobbin case correctly.
Refer to How do I install the bobbin wound with thread? -
Remove the upper thread from the machine.
-
Turn on the sewing machine.
-
Raise the presser foot using the presser foot lever.
(1) Presser foot lever
If the presser foot is not raised, the sewing machine cannot be threaded correctly.
-
Raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up.
(1) Mark on the handwheel
-
Pull up the spool pin as far as possible, and then put a spool of thread on this pin.
If the spool of thread is in the wrong place, or is set incorrectly, the thread may tangle on the spool pin and cause the needle to break.
-
Feed the upper thread as shown in the illustration below.
(1) Spool pin
(2) Thread guide(3) Mark on the handwheel
-
Make sure you guide the thread through the thread take-up lever from right to left.
(1) Thread take-up lever
-
Put the thread behind the needle bar thread guide above the needle.
The thread can easily be passed behind the needle bar thread guide by holding the thread in your left hand, then feeding the thread with your right hand.
(1) Needle bar thread guide
-
Turn off the sewing machine.
-
Pass the thread through the eye of the needle from front to back.
-
Pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.
(1) 5 cm (2 inches)
Related FAQs
ES-2000, XR-6600
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.