NX-600
 |
FAQs & Troubleshooting |
NX-600
Date: 18/01/2008 ID: faqh00000405_000
"Lower the presser foot lever." appears on the LCD.
This message appears when the start/stop button, reverse/reinforcement stitch button, thread cutter button or the foot controller is pressed while the presser foot lever is raised.
- Proper operation will sound
One beep - Improper(wrong) operation will sound
Two or four beeps
CS-8120, Innov-is 100, Innov-is 1200, Innov-is 1250, Innov-is 1500D/1500, Innov-is 2200, Innov-is 350SE, Innov-is 400, Innov-is 500D, Innov-is 550SE/ 550, Innov-is 600, Innov-is 900, Innov-is 950, Innov-is 955, NX-2000, NX-400Q/400, NX-600, QC-1000, SuperGalaxie 3000/3000C/3000D/3100D
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.