Innov-is 27SE
 |
FAQs & Troubleshooting |
Innov-is 27SE
Date: 22/04/2013 ID: faqh00000402_000
An "E7" message appears on the panel.
The needle mode selection key was pressed while a stitch that cannot be used with twin needle sewing was selected.
Select an appropriate stitch, or use single needle sewing.
Each time a key pressed or an incorrect operation is performed, a beep is sounded.
- For a correct operation
One beep is sounded. - If an incorrect operation is performed
Two or four beeps are sounded. - If the machine locks up, for example, because the thread is tangled
The sewing machine continues to beep for four seconds.
The machine automatically stops.
Be sure to check for the cause of the error, and correct it before continuing to sew.
Innov-is 150SE/ 150, Innov-is 20/20LE, Innov-is 200, Innov-is 27SE, Innov-is 30, Innov-is 35, JK4000, JK7000
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.