PR655
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_655euk.jpg)
PR655
Date: 06/07/2006 ID: faqh00000320_000
Why does my thread keep jamming?
The thread could be jamming for several reasons.
- The upper thread could be tangled. Remove the thread completely from the machine.
- The correct size spool cap should be used for the size of the thread spool. Re-thread the machine according to the directions in the manual.
- Remove the bobbin and make sure the bobbin is threaded properly in the shuttle race.
Remove any loose threads or lint in the shuttle race. - The tension could be too tight or too loose. Set the tension to the best thread tension setting or adjust the tension manually.
- The needle and thread are incorrect. Be sure to use the correct thread and embroidery needle.
PR-600/600C, PR-620/620C/600II/600IIC, PR-650, PR650e, PR655
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.