Innov-is 700E
FAQs & Troubleshooting |
Innov-is 700E
Date: 22/06/2006 ID: faqh00000112_000
"Check and rethread the upper thread." appears on the LCD.
- Check if the upper thread is broken.
- Check the upper thread is set up correctly.
- Check the upper thread has not run out.
Be sure to rethread the machine.
If you press the start/stop button without rethreading the machine, the thread tension may be wrong or the needle may break and cause injury.
Each time a key is pressed or an incorrect operation is performed, a beep is sounded.
- For a correct operation
One beep is sounded. - If an incorrect operation is performed
Two or four beeps are sounded. - If the machine locks up, for example, because the thread is tangled
The sewing machine continues to beep for four seconds.
The machine automatically stops.
Be sure to check for the cause of the error, and correct it before continuing to sew.
Innov-is 1200, Innov-is 1250, Innov-is 500D, Innov-is 700E, Innov-is 700EII, Innov-is 750E, Innov-is 900, Innov-is 90E, Innov-is 950, Innov-is 955, Innov-is 97E
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.