PE-DESIGN Ver.4,3,2
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_design4euk.jpg)
PE-DESIGN Ver.4,3,2
Date: 12/01/2016 ID: faqh00000107_000
I receive an error message "No Card Writer Module Is Connected. Please Connect Card Writer Module" when I try to open Design Center or Layout & Editing?
-
Check the interface cable is properly attached to the Card Writer and your PC.
This is usually cased by a conflict with the PC's Modem and the external serial port.
-
Check the Card Writer is powered on prior to opening Design Center or Layout & Editing.
-
Check on which port the modem is assigned to.
- If the modem is assigned to COM1 assign a different port to the modem (COM1 is for the external serial port which is the default for PE-DESIGN).
- If it's not assigned to COM1, there still may be a conflict with your IRQ settings.
-
Remove the modem and reinstall PE-DESIGN.This will assign PE-DESIGN to COM1.
-
Reinstall the modem which will default to a different port.
See the README file installed with the PE-DESIGN software for a detailed explanation.
PE-DESIGN Ver.4,3,2
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.