PX-100/200/300
FAQs & Troubleshooting |
PX-100/200/300
Date: 19/10/2007 ID: faqh00000095_003
How do I clean the bobbin case?
- Remove the power plug from the outlet.
- Raise the needle to its highest position, pull the latch and remove the bobbin case.
- Slide the latch levers out from the retaining ring.
- Remove the retaining ring.
- Remove the hook by grasping the center post and pulling out.
- Remove any accumulated lint and thread with a brush.
- Grasp the center post of the hook, match the hook position opposite the driver and insert.
- Insert the retaining ring with the notch up.
- Push the latch levers into their locked position.Replace the bobbin cace.
Note it’s position related to the driver.
Clean the lint from the shuttle hook using a cloth dampened with machine oil.
JS23, LS-2125, PX-100/200/300, PX-330, XL-5010/5020/5030, XL-5011/5012/5021/5031/5032, XL-5050/5060/5070, XL-5500, XL-5600, XL-5700
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.