Follow the steps below to resolve the issue.

 

Step 1: Check the network connection

Check your Brother machine is available for network print.
If you cannot print, refer the FAQ listed below:

 

(For wired networks)

> Click here to see how to resolve the issue of being unable to print using my Brother machine on a wired network (Windows / macOS).

 

(For wireless networks)

> Click here to see how to resolve the issue of being unable to print using my Brother machine on a wireless network (Windows).

 

 

Step 2: Check the scanner driver

(Windows 11 or later)

Make sure the Brother TWAIN or WIA driver is selected as the primary source in your scanning application.

 

If you cannot find the Brother TWAIN or WIA driver in your scanning application, you need to install the scanner driver.

> Go to the Downloads section of this website and download the Full Driver & Software Package or Scanner Driver.

The installation instructions are available on the download page.

 

(Windows 10 or earlier)

Open scanner list and check the scanner icon of your Brother machine exists there.

> Click here to see how to open "Scanners and Cameras".
 

If the scanner icon of your Brother machine does not exist there, you need to install the scanner driver.

> Go to the Downloads section of this website and download the Full Driver & Software Package.

The installation instructions are available on the download page.

 

 

Step 3: Check the IP Address of your Brother machine

Obtain the machine's IP address by printing a Network Configuration Report.

> Click here to see how to print the Network Configuration Report.

 

 

Step 4: Set the IP Address in the Scanner Driver

NOTE: The steps may differ depending on the operating system being used.

1. Open Scanner Properties.
   > Click here to see how to open Scanner Properties.
2. Click the Network Setting tab and select Specify your machine by address.
3. Enter the IP Address you confirmed in the Step 3 and click OK.
   

 

Step 5: Check the Firewall settings

Check for a Firewall setting on your computer.

If a Firewall on your computer is active, it may be rejecting the necessary network connection needed for the network scanning software to operate properly. Disable the Firewall on your computer and try the network scanning again.

If the feature works properly after disabling the Firewall, this means the Firewall on your computer is rejecting the necessary network connection. In this case, Brother recommends you either disable the Firewall on your computer whenever you need to network scan using the scan key or leave the Firewall enabled and adjust the Firewall settings.

 

Step 6: Uninstall and reinstall the Brother drivers

1. Uninstall and reinstall the Brother drivers.

   If you are using a firewall other than the Windows Firewall or the Windows Firewall is off, you may receive a message warning you that the firewall could block network communication. See the instructions provided with your firewall software for information on how to allow the following network ports:

   • For network scanning, allow UDP port 54925.
   • If you still have trouble with your network connection, allow UDP port 137 and 161.
2. Attempt to scan again to determine if the issue has been resolved. If you are still unable to scan:
   • Verify that there are no security applications or firewalls running on the computer that could prevent network communication.
   • Attempt to scan from another network-connected computer.
   These steps will help you determine if the issue is specific to this computer. If you can scan from other computers, then contact your computer manufacturer or network administrator for assistance troubleshooting this specific computer.