HL-5040
 |
FAQs & Troubleshooting |
HL-5040
Date: 06/11/2006 ID: faq00000231_010
My envelopes are creased.
Please do the following:
If envelopes are creased after they have been printed, please take the following countermeasures:
- Firstly, please change the paper size setting to "DL Long Edge" in the printer driver properties and then put the envelopes in sideways and print again.
- At the back of the printer, open the back output tray and push down the blue tabs at the left and right hand sides (as shown in the figure below). When you have finished printing your envelopes, close the back output tray to reset the two blue tabs back to their original position.
Related FAQs
HL-5030, HL-5040, HL-5050, HL-5070N
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.