MFC-L2740DW
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/mfcl2740dw_us_eu_as.jpg)
MFC-L2740DW
Date: 16/09/2014 ID: faq00000203_038
The faxes I send are always received with a black vertical line down the page.
This type of line is typically caused by dirt or white out (correction fluid) on the scanner unit. The scanner unit is the mechanism that reads the documents that are being sent or copied. This problem is usually solved by cleaning the scanner unit.
Follow the steps below to resolve the issue:
-
Press and hold
(Power On/Off) to turn off the machine.
-
(For automatic 2-sided scanning models) Unfold the ADF document support (1), and then open the ADF cover (2). Clean the white bar (3) and the scanner glass strip (4) underneath it with a soft lint-free cloth moistened with water. Close the ADF cover and fold the ADF document support.
-
Lift the document cover (1). Clean the white plastic surface (2) and scanner glass (3) underneath it with a soft lint-free cloth moistened with water.
-
In the ADF unit, clean the white bar (1) and the scanner glass strip (2) underneath it with a soft lint-free cloth moistened with water.
In addition to cleaning the scanner glass and glass strip with a soft lint-free cloth moistened with water, run your finger tip over the glass to see if you can feel anything on it. If you feel dirt or debris, clean the glass again concentrating on that area. You may need to repeat the cleaning process three or four times. To test, make a copy after each clean.
- Close the document cover.
-
Press
(Power On/Off) to turn on the machine.
MFC-L2700DN, MFC-L2700DW, MFC-L2720DW, MFC-L2740DW
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.