TD-4750TNWBR
![]() |
Usein kysytyt kysymykset ja vianmääritys |
![](/g/b/img/product/lptd4750tnwbreuk.jpg)
TD-4750TNWBR
Päivämäärä: 01/12/2021 Numero: faqp00100468_001
How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer
Follow the instructions below:
- Turn off the printer.
- Press and hold the Feed/Pause Button and then turn on the printer.
-
For the Black Mark Sensor
Release the button when the LED is lit in green (5 times) after the green/red LED blinks five times alternately.
The LED color will change in the following order:
Amber (lit) > Red/Amber (blinks 5 times alternately) > Amber (5 times) > Green/Red (blinks 5 times alternately) > Green (5 times) (Release the button here) > Red (5 times) > Green (lit)
For the Gap Sensor
Release the button when the LED is lit in red (5 times) after the green LED flashes five times.
The LED color will change in the following order:
Amber (lit) > Red/Amber (blinks 5 times alternately) > Amber (5 times) > Green/Red (blinks 5 times alternately) > Green (5 times) > Red (5 times) (Release the button here) > Green (lit)
You can also calibrate by using the BPM (Brother Printer Management Tool).
Jos tarvitset lisäapua, ota yhteys Brotherin asiakaspalveluun:
Sisältöpalaute
Auta meitä parantamaan tukea antamalla palautetta alla.
Vaihe 1: Miten hyödyllinen tällä sivulla oleva tieto on sinulle?
Vaihe 2: Haluaisitko antaa lisäkommentteja?
Huomaathan, että tämä lomake on tarkoitettu ainoastaan palautteen antamiseen.