Hanami 27s
 |
FAQs & Troubleshooting |
Hanami 27s
Date: 27/07/2012 ID: faqh00000477_005
How do I draw up the lower thread by hand? (For models equipped with a quick-set bobbin.)
When sewing gathers or darts, you can draw up the lower thread by hand so that some thread will be left over.
Before you draw up the lower thread, put the bobbin back in.
- Turn off the machine.
- Raise the presser foot lever.
(1) Presser foot lever
- Remove the bobbin cover.
(1) Bobbin cover
- Reinstall the bobbin.
- Pass the thread along the slit in the direction of the arrow, and leave it there without cutting it.
- While lightly holding the end of the upper thread, slowly turn the handwheel toward you (counterclockwise) by hand to lower and then raise the needle.
- Pull on the upper thread to draw up the lower thread.
(1) Upper thread
(2) Lower thread
- Pull out about 10 cm (4 inches) of both threads and put them toward the back of the machine under the presser foot.
(1) Upper thread
(2) Lower thread
- Replace the bobbin cover.
(1) Groove
(2) Projection
AE2700, ArtCity 200, ArtCity 250A, ArtCity 300A, artwork 31, artwork 33A, artwork 37A, BN27, BN37, BQ25, GS2700, Hanami 17, Hanami 25, Hanami 27s, Hanami 37s, JK2500NT, JSL-30, KYOTO, LX27NT, LX3500, LX37NT, ModerN 21, ModerN 27, ModerN 30A, ModerN 39A, RH127, RH137, RS21, RS31, RS40s, RS45s, Satori 100, Satori 200, Satori 300, Satori 400, STAR 17, STAR 25, STAR 27s, STAR 37s, Style 20, Style 25, Style 30s, Style 35s, Universal 17, Universal 25, Universal 27S, Universal 37S, Vitrage M75, Vitrage M77, Vitrage M79, XQ2700, XQ3700
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.