TJ-4121TN
 |
FAQs & Troubleshooting |
TJ-4121TN
Date: 10/12/2021 ID: faqp00100468_004
How to set the Gap/Black Mark Sensor as Media Sensor and calibrate the Gap/Black Mark Sensor by directly operating the printer
Follow the instructions below:
- Turn off the printer.
- Press and hold the Selection button, and then turn on the printer.
-
For the Black Mark Sensor
Release the button when Bline Calibration appears on the Touchscreen.
The LED color will change in the following order:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
For the Gap Sensor
Release the button when Gap Calibration appears on the Touchscreen.
The LED color will change in the following order:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
You can also calibrate by using the BPM (Brother Printer Management Tool).
TJ-4021TN, TJ-4021TNR, TJ-4121TN, TJ-4121TNR
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.