PT-1230PC
 |
FAQs & Troubleshooting |
PT-1230PC
Date: 16/04/2020 ID: faqp00001405_000
What is the E/EL switch on the back of the P-touch labeler for?
This is a "Mode selector switch".
The PT-1230PC has 2 mode selector settings - "EL" (P-touch Editor Lite) and "E" (P-touch Editor).
The mode selector switch is pre-set at the factory to the EL mode.
- For EL mode, you can start P-touch Editor Lite soon without installing software and drivers.
- For E mode, you need to install P-touch Editor which is more advanced labeling software and the required drivers from the [Downloads] section.
- Do not connect the P-touch labeler to your computer before you begin the P-touch Editor installation.
- Make sure that you move the mode selector switch on the back of the P-touch labeler to the "E" position before connecting the USB cable when you want to print a label with the P-touch Editor.
PT-1230PC
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.