Innov-is XP1
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/hf_inovxp1euk.jpg)
Innov-is XP1
Date: 14/09/2018 ID: faqh00101107_000
The amount of thread wound onto the bobbin with the bobbin winder is small.
Possible cause
The bobbin winding slider is set to the less side of the amount of thread wound onto a bobbin.
Remedy
Use the bobbin winding slider to adjust the amount of thread wound onto the bobbin to the level you desire.
|
(1) Bobbin winding slider |
Related FAQs
Innov-is XP1, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.