CS70s
FAQs & Troubleshooting |
CS70s
Date: 22/02/2024 ID: faqh00101093_005
Fabric puckers
-
There is a mistake in the upper or bobbin threading.
Check the steps for threading the machine and rethread it correctly.
Refer to How do I install the bobbin wound with thread ? , How do I thread my machine ?
-
Spool cap is set incorrectly.
Check the method for attaching the spool cap, then reattach the spool cap.
Refer to How do I thread my machine ?
-
Using improper needle or thread for the selected fabric.
Check the Fabric/Thread/Needle Combinations chart.
Refer to Combination of fabric, thread and needle.
-
Needle is turned, bent or the point is dull.
Replace the needle.
Refer to How do I change the needle ?
-
Stitches are too long when sewing thin fabrics.
Shorten the stitch length.
Refer to How do I adjust a stitch width or length ?
-
Thread tension is set incorrectly.
Adjust the thread tension.
Refer to How to adjust the thread tension.
-
Wrong presser foot.
Use the correct presser foot.
Related FAQs
- Combination of fabric, thread and needle
- How do I thread my machine? (For models equipped with the needle threader)
- How do I install the bobbin wound with thread? (For models equipped with a quick-set bobbin)
- How do I change the needle ?
- How do I adjust a stitch width or length?
- How to adjust the thread tension
CS10s, CS120WTs, CS70s, CX70PEs, DS120x, DS50, DX70SE, FS20s, FS40s, FS40WTs, FS45E, FS60x, FS70E, FS70WTx, KD40s, KE20s, SH40, ST55E, STYLE600, X40s
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.