CS10s
FAQs & Troubleshooting |
CS10s
Date: 10/11/2020 ID: faqh00000402_003
"E7" message appears on the LCD.
Cause
This message is displayed when an erroneous operation is performed as follows.
- The foot controller is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.
- The Reverse/Reinforcement stitch button is pressed while the twin needle mode is active, and a stitch pattern that cannot be sewn with the twin needle is selected.
(1) Needle mode indicator
or shows that the twin needle mode is selected.
Solution
-
When you want to sew a pattern you selected :
Switch to the single needle mode, and replace the twin needle with a single needle before continuing the operation.
To change the needle mode, follow the steps below.
-
Turn off the machine.
-
Holding down (Plus key of the stitch selection keys (for digit in the ones place)), turn on the machine.
-
After the machine has turned on, release the key.
The needle mode changes to the single needle mode.(1) Needle mode indicator
or shows that the single needle mode is selected.
-
Turn off the machine.
-
When you want to sew with the twin needle :
Select a pattern that can be sewn with the twin needle.
Refer to "Stitch Chart" to learn stitches that can be sewn with a twin needle.
CS10s, CS120WTs, CS70s, DS120x, DX70SE, FS20s, FS45E, KE20s, X40s
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.