FAQs & Troubleshooting

Close

Innov-is NV1800Q

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is NV1800Q

Not your product?

Date: 17/03/2022 ID: faqh00000135_002

"Change the speed controller mode to "OFF"." message appears on the LCD.

 

Cause

This message is displayed when the sewing speed controller is set to control the zigzag stitch width, and the Start/Stop button is pressed.

 

 

Solution

Use the foot controller to operate the machine.

 

If you want to operate the machine with Start/Stop button, set Width control settings to OFF in the settings screen as follows.

 

  1. Press img01 (Settings key) to display the settings screen.

     

    img02
     
  2. Display the second page of the settings screen by pressing img03 .
    The item img04  (Width control) is selected.
     
  3. Change the value of width control from [ON] to [OFF] by pressing img05 or img06 .

    img07
    (1) img08 : Press this key to move to previous page.
    (2) img09 : Press this key to move to next page.
    (3) img10 : Press this key to select the next item.
    (4) img11 : Press this key to select the previous item.
    (5) img12 : Press this key to change the value of the selected item.
    (6) img13 : Press this key to change the value of the selected item.
    - You can also move to next pages by pressing img14 .

    - Operation panel and operation keys vary depending on your machine model.

    - The page numbers vary depending on your machine model.

    - The parameters in the settings screens differ depending on your machine model.

  4. Press img15 (Back key) or img16 (OK key) to close the settings screen.

Related Models

Innov-is NV1100, Innov-is NV1300, Innov-is NV1800Q

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.