DCP-L2500D
![]() |
FAQs & Troubleshooting |
![](/g/b/img/product/dcpl2500d_eu.jpg)
DCP-L2500D
Date: 24/03/2016 ID: faq00002256_024
Clean the drum unit
If your printout has dots or other repeating marks at 94 mm (3.7 in.) intervals, the drum may have foreign material, such as glue from a label stuck on the drum surface. Follow the steps below to clean the drum unit.
-
Open the front cover.
-
Remove the toner cartridge and drum unit assembly from the machine.
-
Push down the green lock lever and take the toner cartridge out of the drum unit.
-
Turn the drum unit as shown in the illustration. Make sure that the drum unit gear is on the left side.
-
Turn the edge of the drum unit toward you by hand while looking at surface of the suspected area.
-
Wipe the surface of the drum gently with a dry cotton swab until the mark on the surface comes off.
-
Put the toner cartridge firmly into the drum unit until you hear it lock into place.
-
Install the toner cartridge and drum unit assembly back into the machine.
- Close the front cover of the machine.
DCP-L2500D, DCP-L2500DR, DCP-L2520DW, DCP-L2520DWR, DCP-L2540DN, DCP-L2540DNR, DCP-L2560DW, DCP-L2560DWR, MFC-L2700DN, MFC-L2700DNR, MFC-L2700DW, MFC-L2700DWR, MFC-L2720DW, MFC-L2720DWR, MFC-L2740DW, MFC-L2740DWR
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.