Innov-is 900
![]() |
FAQ & Fehlerbehebung |
![](/g/b/img/product/hf_inov900deuk.jpg)
Innov-is 900
Datum: 07.04.2009 Kennnummer: faqh00000475_001
How do I thread the needle?
- When using special thread such as transparent nylon thread or metallic thread, the needle threader cannot be used.
- You cannot use the needle threader if you are using decorative threads or special needles, such as the twin needle and wing needle.
- The needle threader can be used with home sewing machine needles 75/11 through 100/16.
- Never use the thread of No. 20 or lower.
- Use the needle and the thread in the correct combination. For details on the correct combination of needles and threads, refer to "Combination of fabric, thread and needle".
- Lower the presser foot lever to lower the presser foot.
Presser foot lever
- Pull the end of the thread, which has been passed through the needle bar thread guide, to the left, then pass the thread through the notch of the thread guide (
), and then firmly pull the thread from the front and insert it into the slit of the thread guide disk marked "7" all the way (
).
Notch of the thread guide
Thread guide disk
Make sure that the thread passes the notch of the thread guide.
- Cut the thread with the cutter on the left side of the machine.
Thread cutter
- Lower the needle threader lever on the left side of the machine as much as possible to make the hook turn.
Needle threader lever
Needle
Hook
- If the needle threader lever is not lowered as much as possible, the hook will not turn fully as shown below and the thread will not pass through the eye of the needle.
In such a case, start from step 2 again.
- If the needle is not raised, the needle threader cannot thread the needle. Be sure to press
(Needle position button) to raise the needle before using the needle threader.
- If the needle threader lever is not lowered as much as possible, the hook will not turn fully as shown below and the thread will not pass through the eye of the needle.
- Raise the needle threader lever slowly.
Needle threader lever
- Raise the presser foot lever, and carefully pull the loop of the thread through the eye of the needle to pull out the end of the thread.
- When pulling out the thread, do not pull it with extreme force, otherwise the needle may bend or break.
- Do not touch a button. Do not touch the start/stop button, needle position button or reverse/reinforcement stitch button. If one of the buttons is accidentally pressed, the machine will begin sewing and your finger may be pricked with the needle or the needle may break.
- Pass the end of the thread through the presser foot, and then pull out about 5 cm (2 inches) of thread toward the rear of the machine.
5cm (2 inches)
Relevante FAQ
Wenn Sie weitere Unterstützung benötigen, wenden Sie sich an den Brother-Kundendienst:
Rückmeldung zum Inhalt
Helfen Sie uns dabei, unseren Support zu verbessern und geben Sie uns unten Ihre Rückmeldung.
Schritt 1: Wie hilfreich sind für Sie die Informationen auf dieser Seite?
Schritt 2: Möchten Sie noch ein paar Bemerkungen hinzufügen?
Bitte beachten Sie, dass dieses Formular nur für Rückmeldungen verwendet wird.