FAQs & Troubleshooting

Close

PJ-883

FAQs & Troubleshooting

FAQs & Troubleshooting

Date: 09/05/2022 ID: faqp00100045_005

How do I connect the printer to my computer via Wi-Fi®?

  1. Write down the SSID (Network Name) and password (Network Key) of your Wi-Fi access point/router.
  2. Press the Power button.
    The Power Indicator is lit in orange.
  3. Connect the printer and computer using a USB cable.
  4. Download the Software/Document Installer from the [Downloads] section of this website.
  5. Follow the on-screen instructions to proceed with the installation.

    Make sure the checkboxes for [Printer Driver] and [Printer Setting Tool] are checked.

  6. Press the Bluetooth and Wi-Fi button ( Bluetooth/Wi-Fi ) on your printer to turn on the Wi-Fi function.
    Make sure the Bluetooth and Wi-Fi indicator ( Bluetooth/Wi-Fi ) starts flashing in green or cyan once every three seconds.
    If it is flashing in blue, press and hold the Bluetooth and Wi-Fi button for about three seconds. The flashing color changes each time you press and hold it.
  7. Start the Printer Setting Tool on your computer, and click the [Communication Settings] button.
  8. Click [Communication Settings] in the [General] tab.
  9. Select [Infrastructure] for [Selected Interface], and then click [Apply].
  10. Click [Wireless settings] in the [Wireless LAN] tab.
  11. Enter the SSID and password that you wrote down, and then click [Apply].
    When the connection between the printer and your Wi-Fi access point/router is established, the Bluetooth and Wi-Fi indicator is lit in green or cyan. Computers on the same network as the printer will have access to the printer.

    To change any other network settings, use the Printer Setting Tool

  • To configure the Wi-Fi settings again, or if the status of the Wi-Fi connection for your printer is not clear, reset the Wi-Fi settings of the printer.
    1. Confirm that the printer is turned off.
    2. Press and hold the Feed button ( Feed ) and the Power button ( Power ) for about two seconds.
    3. While holding down the Feed button, press the Power button twice, and then release the Feed button.
      The Power indicator ( Power ) starts flashing in orange.
    4. Press the Feed button twice.
  • To see how to connect the printer and a computer using Wireless Direct, see the FAQ: "How do I connect my computer to the printer using the Wireless Direct mode?".

Related Models

PJ-883

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.