QL-1110NWB/1110NWBc
FAQs & Troubleshooting |
QL-1110NWB/1110NWBc
Date: 01/11/2018 ID: faqp00000422_005
Labels are jammed in the machine or are not ejected correctly after printing.
How to remove a label jam:
- Make sure that the printer is turned off and disconnect the AC adapter.
- Open the DK Roll Compartment Cover.
-
Remove any jammed labels.
Do not touch the cutter. Personal injury could result.
How to prevent a label jam:
-
If a label causes the machine to jam due to adhesive residue attached to the label outlet, clean the label outlet with a cloth.
Use a slightly damp cloth if it is difficult to remove adhesive. -
Check if there is dirt or lint on the roller preventing it from rolling freely.
Clean the roller if there is any dirt or lint on it.
For details, see <Roller maintenance> in the FAQ: "How do I clean my printer?". - Check that the label output slot is not blocked.
-
Check that the DK Roll is installed correctly. If not, remove the DK roll and reinstall it.
For details, see the FAQ: "How do I install/change the label roll?". - Check that the DK Roll Compartment Cover is closed correctly.
-
Check that the label is not damp.
Do not expose the DK Roll to high humidity. -
Do not use the label that has been once peeled off by sticking it to the release paper.
It may peel off and get stuck in the printer.
QL-1100/1100c, QL-1110NWB/1110NWBc
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.