Occasionally lint or dirt from the roller may become stuck on the print head and cause poor print quality, white lines or streaks. If this occurs, use the cleaning sheets to clean the roller.

1. Turn off the printer.


2. Hold the DK Roll compartment cover at the sides near the front of the printer and firmly lift it up.
   


3. Remove the DK Roll.
   Be sure to remove the DK Roll before cleaning the roller. The roller cleaning function will not operate correctly if the DK Roll is not removed.
   


4. Thread the end (1) of the Cleaning Sheet into the slot immediately before the cutter.
   
   Do not peel off section (2) of the sheet.
   Make sure that the printed surface of the Cleaning Sheet is facing up.
   


5. After the Cleaning Sheet is inserted in the slot, peel off section (2) of the sheet.
   


6. Close the DK Roll compartment cover.
   


7. Turn on the printer.



8. Press and hold the FEED button for at least one second.
   The roller rotates for 4" (10 cm).
   
   The length of the Cleaning Sheet is 3" (8.5 cm).
   Pressing the FEED button for less than one second makes the roller rotate for 1/3" (8 mm) only.



9. The adhesive surface of the Cleaning Sheet removes dirt and lint from the roller, and cleaning is then completed. A Cleaning Sheet can only be used once.