FAQs & Troubleshooting

Close

Innov-is XP3

FAQs & Troubleshooting

FAQs & Troubleshooting

Innov-is XP3

Not your product?

Date: 05/18/2023 ID: faqh00101548_008

Machine does not start to sew.

 

If the machine does not start when you press the Start/Stop button or press the Foot controller, check the following possible causes and solutions.

 

 

  • There is no stitch selected.

    Select a stitch pattern.
    For details on selecting a stitch pattern, refer to "Basic procedure to sew stitches".


     
  • Presser foot is not lowered.

    Lower the presser foot.

    Refer to "Basic procedure to sew stitches".


     
  • Start/Stop button was pressed with the foot controller attached.

    When the foot controller is connected, you cannot use the Start/Stop button.
    Remove the foot controller to use the Start/Stop button, or use the foot controller to operate the machine.


     
  • The Start/Stop button was pressed while the machine is set to the mode to adjust the zigzag stitch width with the speed control slide. ([Width Control] is set to [ON] in the machine's setting screen).

    When [Width Control] is set to [ON] in the setting screen, you cannot use the Start/Stop button.
    Set the [Width Control] to OFF in the settings screen to use the Start/Stop button, or use the foot controller to operate the machine.

    img01

    Refer to "When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD".


     
  • The operation buttons and keys are locked by being set to the presser foot/needle exchange mode.

    Touch the Presser foot/Needle exchange key img02 to unlock the keys and buttons.

    img03

Related FAQs

Related Models

Innov-is XP1, Innov-is XP2, Innov-is XP3

If you need further assistance, please contact Brother customer service:

Content Feedback

To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.