Innov-is XP1
 |
FAQs & Troubleshooting |
Innov-is XP1
Date: 11/06/2024 ID: faqh00101110_000
Using the embroidery needle plate cover
Under some conditions, based on the type of fabric, stabilizer or thread being used, there may be some looping in the upper thread. In this case, insert the embroidery needle plate cover into the notches on the needle plate as shown below.
 |
(1) Groove (2) Projection (3) Notch |
Push the embroidery needle plate cover as far as possible to attach it. If the embroidery needle plate cover is not securely attached, it may cause the needle to break and cause injury.
To remove the embroidery needle plate cover, place your fingernail in the groove and lift the plate out
Do not use the embroidery needle plate cover for any applications other than embroidery.
Innov-is XP1, Innov-is XP2, Innov-is XP3
If you need further assistance, please contact Brother customer service:
Content Feedback
Please note this form is used for feedback only.