CM350
FAQs & Troubleshooting |
CM350
Date: 01/16/2017 ID: faqh00100596_000
What should I do if part of the material is not cut?
If part of the material is not cut, the cutting pressure may not be set appropriately for the material.
Increase the cutting pressure by 1, and then perform trial cutting.
When the blade is strongly pressed against the material, the material may lift off the mat. If you adjust the cutting pressure, increase by 1.
CM100DM, CM350, CM550DX/ CM550, CM650W
If you need further assistance, please contact Brother customer service:
Content Feedback
To help us improve our support, please provide your feedback below.
Step 1: How does the information on this page help you?
Step 2: Are there any comments you would like to add?
Please note this form is used for feedback only.